Materials Handling Power UNIT one
This power unit is intended for the fork lift marketplace, consisting of extremely effective gear pump, DC motor, manual increase and decrease valve, tank, ect. The up and down motion are controlled through the lever of the guide release valve, which is equipped with an electric switch to activate the motor. The lowing speed is managed through the pressure compensated flow control valve.
one. The duty of this power unit is S3, i.e. 30 seconds on and 270 senconds off.
two. Clean the many hydraulic components concerned just before installation of the electrical power unit.
three. Viscosity with the hydraulic oil shoud be 15~46 cst, which really should also be clean and no cost of impurities, N46 hydraulic oil is advisable .
four. Oil transforming is required immediately after the first a hundred operation hrs, afterwards the moment every single 3000 hours.
five. The power unit shown is built to be mounted horizontally.
Materials Handling Power UNIT 2
This power unit features energy up gravity down circuit. Activate the commence solenoid to begin the motor to lift the machine. The lowing movement is activated through the solenoid valve with the decreasing pace controlled by the strain compensated flow manage valve. Merchandise of this series is often widely used in the business of logistic products for example fork lift, mini lift table, and so forth.
1. The duty of this power unit is S3,i.e.,30 seconds on and 270 senconds off.
2. Clean all of the hydraulic elements concerned prior to mounting the energy unit.
3. Viscosity with the hydraulic oil shoud be 15~46 cst,which need to also be clean and free of impurities, N46 hydraulic oil is advised .
four. Oil transforming is needed just after the preliminary one hundred operation hrs,afterwards after just about every 3000 hours.
5. The electrical power unit need to be mounted horizontally.