one.A connecting link of an O-ring Chain for general application is pre-coated with grease in the pins. In advance of connection, confirm the grease on the surfaces of pins, and in the event the level of grease is modest, apply grease with bare hands. (If gloves are employed, the grease are going to be absorbed by the gloves.)
Example: Once the connecting hyperlink (I) of an O-ring chain for common application is
shipped, O-rings are fitted with the roots in the pins. In the event the O-rings come loose resulting from vibration through transport, refit the O-rings in towards the roots on the pins.
In this case, be sure to return the grease collected on the roots with the pins to the central surfaces on the pins, extra at portion A than at portions B proven in the above illustration. (Portions A is worn as a consequence of sliding using the bushings.)
two.The chain could be most quickly connected over the teeth of the sprocket. Engage the back links at the two ends of your chain with the sprocket teeth and fit connecting pins. If your sprocket is usually moved, the chain may also be connected about the loosened side.
3. Connecting method
1.Verify that O-rings are connected to the roots from the pins.
2.If your level of grease utilized about the connecting pins is smaller, coat the pins with grease in the central portions.
three.Insert the connecting pins in to the bushings of your inner hyperlinks at each ends.
four.Verify the grease is applied to your complete face of the O-ring, and match the O-ring onto the connecting pins.
five.Insert the connecting pins to the connecting plate and when pressing the connecting plate, set up the spring clip. Verify whether the head (the finish with no split) in the spring clip is turned inside the feeding course of the chain. (See the following illustration.)
six.Make sure to verify that the spring clip is securely fitted from the clip grooves of your connecting pins.
This completes jointing with the connecting hyperlink. Note that grease about the surfaces of connecting pins and O-rings is usually eliminated throughout set up work. In this case, re-grease utilizing the grease within the surface with the base chain or even the grease in the polyethylene bag in which the connecting hyperlink was contained.