FSPCR Form Spacer Couplings
The FSPCR Form coupling consists of two flex hubs, two sleeves, a single spacer and two accessory kits. This coupling is provided with exposed bolts as standard. Shrouded bolts can be found upon request by means of size 5.5.
Attributes
For lengthy lifestyle
Typical 20° pressure angle
Heat treated bolts for higher strength
Corrosion resistant bolts and nuts for ease of upkeep
Offers parallel, angular misalignment and finish float
Removal of spacer presents ample area for your elimination of both coupling half with out moving the driver or driven units
Ordering Data
Application: Driver and Driven.
Form and size of coupling, horizontal, vertical and so on.
Power: Motor horspower or torque requirement.
Velocity: Motor RPM or Driven RPM.
Distance concerning shaft ends (BSE).
Shaft sizes.

FSLX Type Extended Slide Couplings
The FSLX Type standard coupling consists of a normal flex half and also a custom created lengthy slide half. The common flex half might be replaced by a reversed and modified hub for additional slide necessity. These couplings may also be supplied which has a plate with lube holes. The coupling is supplied with exposed bolts as common. Shrouded bolts offered on request as a result of size five.5.
Capabilities
For long existence
Conventional 20° pressure angle
Heat handled bolts for greater power
Corrosion resistant bolts and nuts for ease of servicing
Assembled to suit a broad variety of axial motion
Plates with lube holes so each halves in the coupling will likely be adequately lubricated
Ordering Information
Application: Driver and Driven.
Variety and size of coupling, horizontal, vertical and so on.
Electrical power: Motor horspower or torque necessity.
Pace: Motor RPM or Driven RPM.
Distance between shaft ends (maximum-minimum shaft separation).
Shaft sizes.
Level of slide needed.
HL Dimension.
LTB2 Dimension.