Power UNITS FOR LIFT TABLE one
Basic Description
This power unit is built exclusively for the small lift table,Consisting of high strain gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This electrical power unit continues to be broadly applied in the industry of logistic devices which include minifork lift, scissors lift and ariel operating platforms. The lower-ing motion is managed by the solenoid valve together with the velocity controlled through the adjustable needle valve.
Power UNITS FOR LIFT TABLE 2
Common Description
This electrical power unit is designed solely to the medium lift table, Consisting of highly effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing motion is actived by the solenoid valve plus the speed managed through the adjustable needle valve. When the lift rises to a substantial positoin, but the power supply is reduce, the decreasing movement is managed from the manual override perform.
Electrical power UNITS FOR LIFT TABLE 3
Basic Description
This energy unit is made exclusively for that massive lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived through the solenoid valve plus the pace controlled by a stress compensated flow manage valve.
Energy UNITS FOR LIFT TABLE four
General Description
This power unit is intended exclusively for the big lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived through the solenoid valve and the velocity managed by the adjustable needle valve. When the lift rises to a large positoin, but the power supply is lower, the reducing movement is controlled through the guide override function.
Specific Notes
one. This energy unit is of S3 duty cycle, which could only perform intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean every one of the hydraulic components concerned just before installation of the electrical power unit.
3. Viscosity with the oil shoud be 15~46 cst,which must also be clean and absolutely free of impurities.N46 hydraulic oil is encouraged.
four. Oil transforming is required soon after the first a hundred operation hrs,afterwards as soon as each 3000 hrs.
five. The energy unit proven is built to be mounted vertically.